
SDC 2002
4.3. TK Config Menu
4-82
Operating Instructions - Rev. 1 / 6.2003
4.3.6 KEYCODE SETUP
Pressing “Learn Head Offset” opens this window
6.26.1
control buttons
numeric keyline
6.3 6
Fig. 438: Main menu “Tk Config” / submenu “Timecode” / window “Learn Head Offset” opened
Overview
6.1 Window Learn Head Offset / Count & Offset
6.2 Position serves to set the perforation hole at the zero frame mark
6.3 Start / Stop button for head offset processing
6 Learn
Head Offset
This window serves to set the keycode parameter “Keycode position” and
“Head Offset” via learn mode automatically.
6.1 Count + Offset
“Count + Offset” serve to set the film length in feet and frames.
For setting push the “Count + Offset” window.
Numerical buttons will appear at the top of the screen.
Type the requested values and enter with the Ok-button below.
6.2 Position
Serves to set Keycode position (always perf 1 for 16mm films) and determine
the “Zero Frame Reference Mark” at the perforation holes 1 - 4 for 35mm film,
see Fig. 442: .
Comentários a estes Manuais