C*Pix SDC2000 Instruções de Operação descarregar pdf (Página 22)

100

101

SDC 2002

3. Operational Preparations

3-6

Operating Instructions - Rev. 1 / 6.2003

3.4. USER-SPECIFIC CONFIGURATION OF THE FILM SCANNER

3.4.1. CHANGE OPTICAL BLOCK

Changing the optical block (Super16mm, Super35mm/FA 35mm LGA - Lens

Gate Assembly) optically matches the film scanner to the wanted film format.

1. Remove the threaded film from the optical block, if necessary.

2. Unlock the optical block (LGA, lens gate assembly).

For this purpose, move the locking lever on the right of the optical block in up-

wards ccw direction.

3. Seize the optical block at the two handles, pull it out on its guide rails and re-

move it.

Attention! When pulling out the optical block, keep a firm hold on it (approx. 8 kg)!

As soon as the optical block leaves the guide rails, it might be possible that

it slides downwards.

4. Set the new optical block on the guide rails and slide it slowly towards the film

deck plate until it fits.

5. Lock again the lever beside the optical block (position LOCK).

6. Open the film gate locking lever and close it again, to ensure, that the film gate

is not tilt.

7. Perform FPN correction (see section 3.5.).

Handle of the

optical block

Guide rail

Locking lever of the

optical block

Film gate

Film gate locking lever

Fig. 305: Optical block of the film scanner

Change

LGA

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 365 366

Comentários a estes Manuais

Sem comentários

C*Pix SDC2000 Instruções de Operação Página 22

Comentários a estes Manuais

Manuais e produtos relacionados com Câmaras bridge C*Pix SDC2000