C*Pix SDC2000 Instruções de Operação descarregar pdf (Página 305)

SDC 2002 / GCP

4.12 GCP-EVL

4-219

Operating Instructions - Rev. 1 / 6.2003

Scene Change Detection

Events can be added manually to the timeline by pressing Enter & Mark on the

List menu, by pressing the dedicated hardkey (please refer to key assignment)

or automatically by using an external scene change detector.

E.g. SCREAM, the Thomson grain reducer features a built-in scene change

detector which needs no additional cabling.

If enabled the green bar on the button is lit. When using an external device once

check the timing before you start taking in order to avoid mistakes.

Detected scene changes will be added at the end of the list as well as inserted.

To avoid undesired inserts switch it off.

In order to adjust the timing of the automatic scene change detection use the

adjacent setup button. To modify the timing (in frames) use the corresponding

digi-pot or click on it to open the typewriter.

Confirm by hitting OK. The range allows for -10 to +10 frames, the current set-

ting is shown on the key display.

Counter Mode

To change the current counter mode click on this button and chose from the

drop down menu. Timecode, Feet & Frames and Frames is selectable. This

selection affects the timeline display in the list menu. Start scene and scene

duration will be displayed according to the current selection.

Cue Position

This setup determines the frame within an event on which the telecine stops

when in Goto mode.

Click on the button to select from the drop down menu. On first frame, on

frame number.., in center, on last frame is selectable.

If on frame number is selected the adjacent number button gets activated.

To modify the value (in frames) use the corresponding digi-pot or click on it to

open the typewriter.

Enter & Mark determines...

This setup determines wether the TK position has to be on the first or on the

last frame of a scene to enter an event / mark.

No matter which mode is selected the mark will always be on the same position.

The only reason to change this setting is to work in the way your are used to.

Note: In the list display the timecode of the start scene frame is displayed, not

the timecode of the event position.

In first frame mode both are the same but in last frame mode the displayed time-

code varies by one frame !

1 2 ... 300 301 302 303 304 305 306 307 308 309 310 ... 365 366

Sem comentários

C*Pix SDC2000 Instruções de Operação Página 305